Terry_Cowan (16K)




Other Albums By Kerry Pinkerton

Browse All Albums

Created By: Kerry Pinkerton


Art Deco Imperial (16)
Sort by Title  Sort by Size
9990332310695.jpg
outside4.jpg
(16.88 KB)

9970332310694.jpg
outside3.jpg
(21.18 KB)

9980283179618.jpg
a sketch1.jpg
(21.49 KB)

"Kerry Draw' of what the rear view might look like.
9980332310694.jpg
outside2.jpg
(23.69 KB)

9990332310694.jpg
outside1.jpg
(31.05 KB)

9980283660465.jpg
burtbuck45.jpg
(32.81 KB)

Flexible shape pattern on top of Burt Buck
9990283180071.jpg
burtbuck30.jpg
(38.28 KB)

Aluminum cleco'ed in place. BurtBuck mockup of the rolled pan
9970283660465.jpg
burtbuck46.jpg
(41.24 KB)

Flexible pattern on door
9990283660465.jpg
burtbuck44.jpg
(45.19 KB)

9980283385989.jpg
burtbuck44.jpg
(45.19 KB)

Completed rolled pan. The right hand half of it kicked my butt...lots of change in shape and arrangement throughout its length.
9980283660466.jpg
burtbuckA48.jpg
(54.78 KB)

Strip structure for supporting Burt Buck
9980283179619.jpg
burtbuck19.jpg
(64.37 KB)

Front part of the fender showing the reverses that make up the center part of the fender/body assembly.
9990283179619.jpg
burtbuck42.jpg
(66.33 KB)

Rear view of the fender/body assembly cleco'ed in place.
9970283179618.jpg
mm07-3.jpg
(74.02 KB)

This was the bare chassis before I swapped over to the Corvette suspension. The fender bucks are foam and bondo.
9990283660466.jpg
burtbuck47.jpg
(84.51 KB)

Burt Buck...see long description
9990283179618.jpg
A side8.jpg
(121.30 KB)

Photoshop 'drawing' of what the car should look like




This site and its pages are Metalshapers Association 2005.

All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. Click here for details.

Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks.


This site is hosted by the Metalshapers Association