Terry_Cowan (16K)
Dagger Tools




Other Albums By Ron Naida

Browse All Albums

Created By: Ron Naida

Wire Edges Hand Method (4)
Sort by Title  Sort by Size
9990113559519.jpg
Mvc-011s
(31.10 KB)

Cut out 20 gage blank. Start 90 bend up with pliers. A couple wood blocks as hammerforms for the tight areas may be needed
9980113559519.jpg
mvc-016s
(55.22 KB)

Wire in, clinched over. Final hammering and dolly
9970113559519.jpg
Mvc-017s
(30.07 KB)

Roll forming by lightly clamping the piece of wood. Then pull the metal through while pushing down
9960113559519.jpg
Mvc-019s
(36.57 KB)

Trim and fit panel for completion. Old on top of new




This site and its pages are © Metalshapers Association 2005.

All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. Click here for details.
 
Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks.


This site is hosted by the Metalshapers Association