Metalshapers Assoc. Community Sites

clamping tools (13)

calmping tools 002.jpg (63.18 KB) 90 degree clamp with swivel so it stays flat on any thickness material	calmping tools 007.jpg (62.21 KB) I think faster than I type, I miss spelled clamping in the title	calmping tools 011.jpg (62.49 KB) For lining up two pieces of pipe or rod
calmping tools 012.jpg (62.50 KB) I use these a lot when making headers	calmping tools 013.jpg (61.32 KB)	calmping tools 018.jpg (61.01 KB) I TIG weld left handed, so I angled the clamp to the right
calmping tools 019.jpg (63.17 KB) another advantage of being angled	calmping tools 020.jpg (63.10 KB) The back side	calmping tools 021.jpg (63.13 KB)
calmping tools 022.jpg (60.88 KB) The way I used to do it... Still usefull idea for irregular shaped stuff	calmping tools 025.jpg (62.73 KB) obiously I didn't make this. every shop should have one	calmping tools 026.jpg (62.10 KB) this is a Gibralter, made in China. I got it from MSC
calmping tools 027.jpg (60.85 KB) Bessey makes one that is four times more expensive

This site and its pages are � Metalshapers Association 2005.

All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. Click here for details.

�

Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks.

This site and its pages are � Metalshapers Association 2005.

This site is hosted by the Metalshapers Association