Terry_Cowan (16K)




Other Albums By Kerry Pinkerton

Browse All Albums

Created By: Kerry Pinkerton


Kerry Pinkerton's MSA Planishing Hammer (10)
Sort by Title  Sort by Size
9990305006585.jpg
hpim0771.jpg
(39.98 KB)

Rear bell crank under the base
9950305006584.jpg
hpim0772.jpg
(35.61 KB)

Front adjustment under the base going into the flexible cable.
9960305006584.jpg
hpim0773.jpg
(39.71 KB)

Footpedal
9970305006584.jpg
hpim0774.jpg
(53.38 KB)

Air hammer cast head with air motor CP type II
9980305006584.jpg
hpim0775.jpg
(48.59 KB)

Mid arm socket. It moves side to side as well as in and out. Brass set screw locates directional dies.
9990305006584.jpg
hpim0776.jpg
(34.46 KB)

Die storage
9980305006583.jpg
hpim0777.jpg
(55.51 KB)

Kind of hard to see but this is the cap on the vertical DOM tube. The cap has a yoke welded to the bottom and a bell crank that translates vertical movement up the tube to movement in the upper arm. At the other end of the upper arm is another bell cran
9990305006583.jpg
hpim0778.jpg
(71.09 KB)

9990305006725.jpg
mvc-409f.jpg
(45.09 KB)

MSA style planishing hammer
9980305006725.jpg
mvc-410f.jpg
(46.60 KB)

Detail of the mechanism. All linkage runs inside the upper arm, DOM tubing, and under the base.




This site and its pages are Metalshapers Association 2005.

All rights to the content presented on this site is retained by its original authors or the Metalshapers Association, and appears here under license. Any use by third parties requires permission from the original author. All rights reserved. Click here for details.

Some of the equipment and methods shown on this site can cause SERIOUS INJURY or DEATH if used improperly or with negligence. The display of equipment or methods here does not constitute endorsement or insure suitability for any particular use. The user is entirely responsible for their own actions, and assumes any and all associated risks.


This site is hosted by the Metalshapers Association